Pystyykö tuota edes yleismittarilla testaamaan.
Eikös se tarvitse virtaa toimiakseen.
Tuolla on ohjeet yksinkertaisen testerin tekemiseen.
Hall anturin korjaus
Diodiksi käy vaikka Bilteman merkkidiodi nro 43043. Hinta huimat 1.99 euroa.
Siinä on etuvastus jo mukana.
Paristoksi esim. 9V paristo.
Tuolla vehkeellä kun testaa, niin oikea kohta on siinä, kun diodi sammuu.
Pekka
Edit
PS. Lueskelin vielä tuota Hall-anturi ohjetta.
Olihan siellä myös konsti millä sytytyksen voi testata yleismittarilla:
To test with a volt meter, plug the sensor plate in to the bike and switch on the ignition. Put the negative clip to a good earth on the frame and the positive probe to the Orange wire in the coupler (upper sensor). Watch the meter as you slowly turn the engine clockwise (viewed from the front).
Timing is correct when the voltage drops to zero and the line below the OT mark (TDC) is showing central in the window,
Tuossa Hall anturissa se vihreä johto on toi signaalijohto, jota pitää mitata.